Palsonic PMO-555 - Manual (Page 3)

INSTALLATION
1. Make sure all the packing materials are re-
moved from the inside of the door.
2. Inspect the oven after unpacking for any vi-
sual damage such as:
Misaligned Door
Damaged Door
Damaged Door Seal
Dents or Holes in Door Window and Screen
Dents in Cavity
If any of the above are visible, DO NOT
use the oven
enough to support this weight.
4. The oven must be placed away from high
temperature and steam.
5. DO NOT place anything on top of the oven.
6. Keep the oven at least 8 cm away from both
sidewalls and 10 cm away from rear wall to
ensure the correct ventilation.
7. DO NOT remove the turn - table drive shaft.
8. As with any appliance, close supervision is
necessary when used by children.
3. This Microwave Oven weighs 12.5 kg and
must be placed on a horizontal surface strong
WARNING - THIS APPLIANCE MUST BE EARTHED.
1. The power cord is 1.4 m long, the plug socket should be within easy reach of this cord.
2. This oven requires 0.9 KVA for its input.
consultation with service engineer is suggested CAUTION: This oven is protected internally
when installing the oven. by a 250V, 6 Amp Fuse.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following code:
Green - and - yellow : Earth
Blue
: Neutral
Brown : Live
As the colours of the wires in the mains leads of the appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured green - and - yellow must be connected to the terminal in the
plug which is marked with the letter E or by the earth symbol-coloured green or green -
and - yellow
The wire which is coloured blue must be connected to the terminal which is marked with the
letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with
the letter L or coloured red.
2