Paradyne 9550 DS3 - Manual (Page 10)

10
7. If the cable length is longer than 100 feet (30 meters), set the LBO on the T3
Network Interface Options configuration screen to Long. The default is Short. See
the iMarc SLV Configuration Reference.
Connecting the Ethernet Port
The Ethernet port provides a 10/100BaseT connection that can be used for Telnet, FTP,
and SNMP access to the Probe.
Procedure
To connect the Probe to an Ethernet hub, switch, or NIC:
1. Select the correct cable:
— To connect the LAN port to a hub, use a standard Ethernet MDI cable
— To connect the LAN port to a NIC, use an Ethernet MDIX (crossover) cable
2. Insert the 8-pin modular connector of the cable into the Ethernet jack on the Probe.
It locks in place when it is fully seated.
3. Fix the cable to the rail with a cable tie or other strain relief device.
4. Connect the other end of the cable to your LAN or NIC.
05-17704
LAN
Rx
Tx
Rx
Tx
NETWORK
SUBSCRIBER
ETHERNET
MODEM
CONSOLE
POWER ALARM TEST OK
YEL AIS LOS OOF
SUBSCRIBER
NETWORK
LCV RD RX TD TX
ATMC ATMS