Printronix SLPA8000r MP2 - Manual (Page 4)

RFID Label Guide Specification
Gen 2, Rafsec Short Dipole Antenna
182316-000 Rev C Page 4 of 5
3.7.3.1. Printable label facestock width with inlay is 6.6" (167.6 mm).
Maximum width of label construction supported by printer is 6.8"
(172.7 mm) edge to edge.
3.7.4. Minimum supported inlay pitch is 2.0" (50.8 mm).
3.7.5. Gap Sensing
3.7.5.1. Nominal gap between labels for gap sensing is 0.125" (3.17 mm).
Minimum gap supported is 0.10" (2.54 mm).
3.7.5.2. 1.0" (25.4 mm) minimum x 0.125" (3.17 mm) timing marks on the liner
under the gap.
3.7.6. Release Characteristics
3.7.6.1. Labels shall be able to dispense in a print and apply application.
3.8. Packaging and Handling
3.8.1. RFID labels are static sensitive devices and should be packaged and handled
accordingly.
3.8.2. Low humidity environments can increase electrostatic discharge (ESD) conditions.
ESD safeguards are recommended
3.8.3. Avoid storing labels in elevated temperature environment.
4. Thermal Transfer Ribbons for Printronix RFID Printers
4.1. Ribbons for 4” RFID Printer Models
4.1.1. Wax resin ribbon for best durability. Wax Resin Blend Ribbon 8500, 4.33" x 2051'
(110 mm x 625 m), package of 6 ribbons, Printronix part no. 203485-103.
4.1.2. General purpose wax ribbon. Wide Spectrum Wax Ribbon 8300, 4.33" x 2051'
(110 mm x 625 m), package of 6 ribbons, Printronix part No. 175391-103.
4.2. Ribbons for 6” RFID Printer Models
4.2.1. Wax resin ribbon for best durability. Wax Resin Blend Ribbon 8500, 6.73" x 2051'
(171 mm x 625 m), package of 6 ribbons, Printronix part no. 203485-106.
4.2.2. General purpose wax ribbon. Wide Spectrum Wax Ribbon 8300, 6.73" x 2051'
(171 mm x 625 m), package of 6 ribbons, Printronix part No. 175391-106.
5. Contact Information
5.1. For comments or questions, please contact Andrew Moore at [email protected] or
714-368-2477.