Patton electronic 2158 - Manual (Page 14)

14
4.0 CONFIGURATION (MODEL 2168 ONLY)
The CopperLink Ethernet Extender has eight DIP switches for configur-
ing the unit for a wide variety of applications. This section describes
switch locations and explains the different configurations.
4.1 CONFIGURING THE HARDWARE DIP SWITCHES
Using a small flat-tip screwdriver, remove the protective cover located on
the underside of the CopperLink Ethernet Extender (see Figure 9).
Figure 9. Removing protective cover
Figure 10 and Figure 11 on page 15 show the orientation of the DIP
switches in the On and Off positions.