Psion Teklogix 9160 G2 - Manual (Page 310)

Appendix C: Security Settings On Wireless Clients And RADIUS Server Setup
IEEE 802.1x Client Using EAP/TLS Certificate
C-18 Psion Teklogix 9160 G2 Wireless Gateway User Manual
1. Configure the following settings on the Association tab on the Network
Properties dialog.
2. Configure these settings on the Authentication tab.
3. Click Properties to bring up the Smart Card or other Certificate Prop-
erties dialog and enable the Validate server certificate option.
Click OK on all dialogs to close and save your changes.
4. To complete the client configuration you must now obtain a certificate
from the RADIUS server and install it on this client. For information on
how to do this see “Obtaining A TLS-EAP Certificate For A Client” on
page C-34.
Network Authentication Open
Data Encryption WEP
Note: An RC4 stream cipher is used to encrypt the frame body and cyclic redun-
dancy checking (CRC) of each IEEE 802.11 frame. This is the same
encryption algorithm as is used for Static WEP; therefore, the data encryp-
tion method configured on the client for this mode is WEP.
This key is provided for
me automatically Enable (click to check) this option.
Table C.7 Association Settings
Enable IEEE 802.1x authentication for this network Enable (click to check) this option.
EAP Type Choose Smart Card or other Certificate.
Table C.8 Authentication Settings
Validate Server Certificate Enable this option (click to check the box).
Certificates In the certificate list shown, select the certificate for this client.
Table C.9 Smart Card Or Other Certificate Properties Settings