Pioneer AVH-P4900D - Manual (Page 15)

Touch to select various setup functions.
4 BACK key
Touch to return to the previous display.
5 ESC key
Touch to cancel the control mode of func-
tions.
1 Press A.MENU button to display MENU.
MENU appears on the display.
2 Touch the desired key to display the
function names you want to operate.
# To go to the next group of function names,
touch
NEXT.
# To return to the previous group of function
names, touch
PREV.
3 Touch ESC to return to the display of
each source.
Note
If you do not operate the function within about 30
seconds, the display is automatically returned to
the playback display.
Opening and closing the LCD panel
The LCD panel will be opened or closed auto-
matically with the turning of the ignition
switch on or off. You can turn off the automatic
close/open function. (Refer to page 42.)
! Do not close the LCD panel with hands by
force. That cause malfunction.
! The automatic close/open function will op-
erate the display as follows.
— When the ignition switch is turned OFF
while the LCD panel is opened, the LCD
panel will close after six seconds.
— When the ignition switch is turned ON
again (or turned to ACC), the LCD panel
will be opened automatically.
— Removing or attaching the front panel
will automatically close or open the LCD
panel. (Refer to page 10.)
! When the ignition switch is turned OFF
after the LCD panel has been closed, turn-
ing the ignition switch ON again (or turning
it to ACC) will not open the LCD panel. In
this case, press
OPEN/CLOSE to open the
LCD panel.
! When closing the LCD panel, check to
make sure that it has closed completely. If
the LCD panel has stopped halfway, leaving
it like this could result in damage.
CAUTION
Keep hands and fingers clear of the unit when
opening, closing, or adjusting the LCD panel. Be
especially cautious of children
’s hands and fin-
gers.
% Press OPEN/CLOSE to open the LCD
panel.
# To close the LCD panel, press OPEN/CLOSE
again.
Adjusting the LCD panel angle
Important
! If you can hear the LCD panel knocking
against your vehicle
’s console or dashboard,
press ANGLE (
–) to move the LCD panel a lit-
tle forward.
! When adjusting the LCD panel angle, be sure
to press ANGLE (+/
–). Forcibly adjusting the
LCD panel by hand may damage it.
Operating this unit
En
15
Section
03
Operating
this
unit