Philips HSB4383/12 - Manual (Page 16)

17
Turn on
1
Press .
The unit switches to the last selected
»
source.
2
Wait for automatic setup of wireless
connection between the main unit and
subwoofer.
» [PAIRING] (pairing) fl ashes.
If the connection succeeds,
»
[PAIR OK]
(pair OK) is displayed and the blue
indicator on the subwoofer lights up.
If the connection fails,
»
[PAIR FAIL]
(pair fail) is displayed and the green
indicator on the subwoofer lights up.
If the wireless connection fails, set up
»
the connection manually.
Set up wireless connection manually
1
In Normal Standby mode (see “Adjust
Settings - General Setup - [Standby
Mode]”), press and hold
on the main
unit for 3 seconds.
» [PAIRING] (pairing) fl ashes.
2
Press and hold PAIR on the subwoofer for
3 seconds.
The blue and green indicators on the
»
subwoofer fl ash alternately.
If wireless connection succeeds,
»
[PAIR
OK] (pair OK) is displayed and the
blue indicators on the subwoofer lights
up.
3
Turn on the main unit again.
4 Get started
Caution
Use of controls or adjustments or performance of •
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat, •
sunshine or fi re. Never discard batteries in fi re.
Risk of decreased battery life! Never mix different
•
brands or types of batteries.
Risk of product damage! When the remote control is
•
not used for long periods, remove the batteries.
1
Open the battery compartment.
2
Insert two R03 or AAA batteries with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
3
1
2
English
EN