ProForm 15.5 s 831.28622.1 - Manual (Page 8)

8
9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
8. Apply a small amount of grease to the axle on
the left Disc Crossbar (16).
Slide the Left Pedal Leg (11) onto the axle on
the left Disc Crossbar (16). Apply a small
amount of grease to a Large Wave Washer (76)
and press it onto the end of the Left Pedal Leg.
Next, slide an M10 Washer (35) onto an M10 x
27mm Patch Screw (40), and tighten the Patch
Screw into the axle. Then, press a Pedal Leg
Endcap (74) into the Left Pedal Leg.
Hold the lower end of the left Handlebar Leg (5)
inside of the bracket on the front of the Left
Pedal Leg (11). Next, apply grease to an M6
Bolt Set (25). Attach the Handlebar Leg to the
Left Pedal Leg with the Bolt Set. Do not over-
tighten the Bolt Set; the Handlebar Leg must
pivot freely.
Attach the Right Pedal Leg (not shown) to the
right side of the elliptical exerciser in the same
way.
See step 5. Tighten the M10 x 74mm Button
Bolts (7) in the Upright (2). See step 6. Tighten
the M8 x 45mm Button Bolts (50) in the
Handlebar Legs (5).
Grease
25
11
25
5
2
Grease
16
40
74
35
76
11
8
7
27
71
11
13
71 28
28
7. Identify the Left Pedal Leg (11), which is
marked with a sticker. Attach the Left Pedal (13)
to the Left Pedal Leg with two M8 x 52mm
Button Screws (27), two M8 Split Washers (28),
and two M8 Washers (71).
Attach the Right Pedal (not shown) in the same
way.