ProForm PFCG2224.0 - Manual (Page 5)

5
ASSEMBLY
1.
Attach the Front Stabilizer (3) to the Base (1) with
two M10 x 78mm Carriage Bolts (50) and two
M10 Nylon Locknuts (64).
Do not tighten the
Locknuts yet.
2. Attach the Rear Stabilizer (2) to the Base (1) with
two M10 x 78mm Carriage Bolts (50) and two
M10 Nylon Locknuts (64).
Tighten the M10 Nylon Locknuts (64) used in
steps 1 and 2.
1
64
64
1
3
50
2
Before beginning assembly, make sure you
understand the information in the box
above. For help identifying small parts, use
the PART IDENTIFICATION CHART in the
center of this manual.
64
2
1
50
To hire an authorized service technician to
assemble the exercise bench, call toll-free
1-800-445-2480.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
The included hex key(s) , and the
following tools (not included) may be required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Clear tape or masking tape, and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by anyone. Most people find that by
setting aside plenty of time, assembly will go
smoothly.