Panasonic TC 22LH1 - Manual (Page 31)

31
Operating peripheral equipment using the remote control
The Universal Remote Control can be programmed to operate many manufacturers’ components, using the
component function buttons for TV, VCR, DBS/CABLE or DVD. Follow the procedures for programming
your Remote Control with or without a code for the component.
Determine the manufacturer of the component and look in the table for the code.
Programming The Illuminated Remote Control Using Access Codes
1
Confirm that the external component is plugged in and operating.
2
Turn the component off.
3
4
5
Press the mode key.
The mode key will illuminate steadily, all others will go out.
Enter the 3-digit component code using the Remote Control numeric
keypad.
6
POWER +
VCR
DV
D
DBS/CBL
TV
1 2 3
4 5 6
7 8
0
9
POWER
Press the Remote Control POWER to test the component. If the
procedure is successful, the component will turn on.
If the component does not operate with the Remote Control, repeat the procedure using
another code. (Some brands have multiple codes).
If an incorrect code is entered, or if the procedure takes longer than 30 seconds,the
programming will fail.
Helpful Hints: Unsuccessful Code
Device
TV
VCR
DBS/CBL
DVD
Operates
TV (Panasonic Only)
VCR (Preset)
DBS (Preset), CABLE (Preset)
DVD (Preset)
Default
Panasonic TV Codes
Panasonic VCR Codes
Panasonic DBS Codes
Panasonic DVD Codes
Default Modes For Remote Control
CH
CH
VOL VOL
O K Press POWER and OK together, for at least 5 seconds.
After 5 seconds, all the illuminated mode keys will begin to flash.
Release the POWER and OK keys.