Pentair PDA - Manual (Page 3)

ScreenLogic PDA Quick Start Guide
PDA First Time Setup Instructions
Thank you for purchasing the IntelliTouch ScreenLogic PDA
interface. Before you can use your PDA to operate your
ScreenLogic system, you need to setup the ScreenLogic PDA
program. The PDA must be in its cradle with power connected.
Charging the PDA
You need to charge the main battery and internal backup battery
from empty to full. This takes about 8 hours the first time and 4
hours thereafter, whether the device is on or off.
IMPORTANT: When you are not using your ScreenLogic PDA,
please return it to the cradle to replenish the battery. The PDA can
still be operated wirelessly in the cradle. The battery is good for
about a week without operation, and 2 to 3 hours of continuous
use.
Setting up the PDA for the first time
Before setting up the ScreenLogic PDA program, connect the AC
adapter to the cradle and to an electrical outlet, and insert the PDA
into the cradle.
Note: The following setup procedure assumes that you have
already connected the ScreenLogic wireless router and
Protocol adapter to a working IntelliTouch system.
To setup the ScreenLogic PDA program:
1. Press the power button on the front of the PDA. The Dell
opening screen is displayed.
2. Using the stylus, tap on the screen to setup your pocket PC.
3. Tap in the center of the 5 cross-hairs as they move across the
screen to align the touch screen.
4. Tap Next on the following screen.
1
ScreenLogic PDA Quick Start Guide
4
Notes