Panasonic PT-50DL54X - Manual (Page 8)

6 z
I NSTALLATION
ENGLISH
Remote Control Battery Installation
Requires two AA batteries (supplied) .
Procedure
1. Remove battery cover by pushing in on the catch while
lifting the cover up.
2. Install batteries by matching (+) and (-) polarity signs in
the compartment.
3. Re-insert the cover and press down the cover until it
snaps shut.
Note: Incorrect installation can cause battery leakage and
corrosion that will damage the Remote Control.
Precautions
• Replace batteries in pairs.
• Do not mix battery types (zinc carbon with alkaline).
• Do not recharge, heat, short-circuit, disassemble, or
burn batteries.
Replacing the lamp unit
(For USA and Canada only)
(USA only)
The lamp unit is sold separately Lamp unit Part No. :
TY-LA2004. To purchase a replacement, call the
Panasonic accessory department, toll free at:
1-800-332-5368.
(Canada only)
For product operation and information assistance, please
contact your Dealer or our Customer Care Centre at:
(905) 624-5505.
Lamp unit replacement period
The lamp unit for the projection TV should be replaced after
approximately 10,000 hours of use in the normal usage
mode. Due to the characteristics and use conditions of
individual lamps, the lamp may cease to light before the
stated lamp life. Influences of frequent lighting, continuous
light use for over 24 hours, the number of times lit, the
length of time between lightings, etc. may shorten lamp life.
Because of this, having a replacement lamp on hand is
recommended.
A warning will display after 10,000 hours of use. When the
power is turned on after 10,000 hours of continued use,
REPLACE LAMP will be displayed for approximately 1 min.
A warning message to urge the replacement of the lamp
will be displayed in red at the center of the screen.
Important Points to keep in mind
When replacing the lamp unit, pay attention to the following
points.
Warning:
• The lamp unit is hot during operation and touching it
immediately after use may cause burns.
• Please allow the lamp to cool (for at least 1 hour)
before handling or replacing the lamp unit.
Cautions for Lamp Unit Replacement:
• Handle the old lamp unit carefully. If mishandled, it may
explode.
• Wear gloves when replacing the lamp unit.
• If replacing the lamp unit becomes necessary during the
operation of the TV, follow the procedure below to turn
off the power and wait until the lamp unit cools
completely.
Procedures to turn Power Off
1. Press the POWER button to turn off the power.
2. Wait for about one minute until the cooling fan stops.
Note: The lamp cooling fan will continue to operate for about
one minute after turning off the power. Do not unplug the
power cord from the outlet until the fan has stopped.
Avoid interrupting the power line such as by using circuit
breakers or switchable power strips.
3. Unplug the power cord from the outlet.
+
-
+
-
+
+
-
+
-
1 2 3
REPLACE LAMP
For USA and Canada only.
Refer to the instructions enclosed with the lamp unit
(Part No. TY-LA2004) when replacing the lamp.