Panasonic KX-TG4132 - Manual (Page 43)

Useful Information
43 For assistance, please visit http://www.panasonic.com/help
Answering system
Liquid damage
Caution:
L
To avoid permanent damage, do not use a microwave oven to speed up the drying process.
Problem Cause/solution
The unit does not record new
messages. L The answering system is turned off. Turn it on (page 29).
L The message memory is full. Erase unnecessary
messages (page 30).
L The recording time is set to “Greeting only”. Change
the setting (page 33).
L If you subscribe to a voice mail service, messages are
recorded by your service provider/telephone company,
not your telephone. Change the unit’s number of rings
setting or contact your service provider/telephone
company (page 33).
I cannot operate the answering
system. L Someone is using the unit. Wait for the other user to
finish.
L A caller is leaving a message. Wait for the caller to finish.
L The handset is too far from the base unit. Move closer.
I cannot operate the answering
system remotely. L The remote access code is not set. Set the remote access
code (page 31).
L You are entering the wrong remote access code. If you
have forgotten your remote access code, enter the
remote access code setting to check your current code
(page 31).
L Press each key firmly.
L The answering system is turned off. Turn it on (page 32).
Problem Cause/solution
Liquid or other form of moisture
has entered the handset/base
unit. L Disconnect the AC adaptor and telephone line cord from
the base unit. Remove the batteries from the handset and
leave to dry for at least 3 days. After the handset/base
unit are completely dry, reconnect the AC adaptor and
telephone line cord. Insert the batteries and charge fully
before use. If the unit does not work properly, contact an
authorized service center.
TG413x(e).book Page 43 Tuesday, December 7, 2010 8:01 AM