Hardware commands, Show server, Set ethernet show hardware – Perle Systems DS1 User Manual
Page 79
Command Line Interface 79
Server Commands
Show Server
Description Shows the parameters set for the server.
User Level Admin
Syntax
Hardware Commands
Set Ethernet
Description Sets the serial line speed and duplex.
User Level Admin
Syntax
Options
auto|10-half|10-full|100-half|100-full
Show Hardware
Description Shows the hardware settings/information.
User Level Normal, Admin
Syntax
spcd
SPC (Trueport) daemon process in the Device Server on port 688.
syslog
Syslog client process in the Device Server.
dmgrd
DeviceManager daemon process in the Device Server. If you disable this service, you
will not be able to connect to the Device Server with the DeviceManager application.
DeviceManagerD listens on port 33812 and sends on port 33813.
show server
set ethernet speed-and-duplex
auto|10-half|10-full|100-half|100-full
Define the ethernet connection speed at one of the following:
z
auto
—automatically detects the ethernet interface speed and duplex
z
10 Mbps Half Duplex
z
10 Mbps Full Duplex
z
100 Mbps Half Duplex
z
100 Mbps Full Duplex
show hardware