Panasonic AW-RC600P - Manual (Page 13)

13
Connections
 Before proceeding with the connections, ensure that the power to all the devices is off.
 Be absolutely sure to use the AW-CA50A26 RCU cable to connect the RCU to the camera.
 When extending the cable, use the extension-use studio cable (WV-CA26U15, WV-CA26U30 or WV-CA26U100) and
extension-use joint connector (WV-CA26T26).
 The maximum length to which the cable can be extended is 984 ft. (300 m) (for a camera body and lens).
When using the studio card (AW-PB305) and attaching a viewfinder, it can be extended up to 328 ft. (100 m).
 When the power switch of the RCU is set to ON, the power indicator LED lights up, and the camera is controlled from the
RCU.
Notes:
 When the R/G/B, Y/PR/PB and Y/C signals are used, select the required signals using the camera’s menu.
 When using the S-Video signals, select Y/C using the camera’s menu. Furthermore, use either the S-Video connector or
BNC connectors, and leave the other connectors unconnected.
The S-Video connector and BNC connectors cannot be used at the same time.
 Connect either the VIDEO OUT BNC connector or S-Video connector to the AW-SW350 live switcher.
 Use an intercom headset suited to all the devices.
 Fabricate the TALLY & INCOM cables without mixing up the signals.
Remote control unit
AW-RC600
AC adapter
AW-PS505A
Live switcher
AW-SW350
Convertible camera + lens +
electronic viewfinder
The AW-PB305 studio card and viewfinder installation bracket are
required to connect an electronic viewfinder to a convertible camera.
Headset
AC 120 V
Supplied AC cable
TALLY&INCOM
VIDEO IN (S-VIDEO)
To VIDEO IN
To PGM OUT or PVW OUT
To BB OUT
TALLY&INCOM cable
S-VIDEO cable
BNC coaxiale cable
To RGB monitor, etc.
RCU cable
AW-CA50A26
50-pin connector
of camera
AC120 V
BNC coaxiale cable
BNC coaxiale cable
Headset
Headset