Precor EFX 883 - Manual (Page 37)

Installing the Console
35
Completing the Console Installation (P80)
Important: To allow enough room to attach the console’s back
cover, you must loosen the bracket holding the upper ends of the
handlebars in place. If you do not loosen the bracket, the cover
may break. Using a ³₁₆ -inch hex key, loosen the two socket head
cap screws in the bracket by two or three turns each.
Figure 29: Location of screws on handlebar bracket
Before you complete the final installation steps, double-check
the connections you have made. Make sure that all cables are
fully and securely connected, and that any unneeded cables
are tied back properly.
To complete the installation:
1.
Feed extra cable back into the neck tube.
2. Tilt the control console backward (toward yourself) until
the tab on the top edge of its back plate slides along the
top edge of the console mount and the screw holes align
properly.
3. Insert the four ⁵₈-inch flat head screws through the holes
in the console mount and thread them into the holes in
the back plate on the console. Partially tighten the screws
using a ⁵₈-inch hex wrench.
4. Line up the two small tabs at the top of the console’s back
cover with the slots at the top of the opening in the
console case. Insert the tabs into the slots.
5. Insert the remaining tabs on the back cover with the
corresponding slots on the console case.
6. Press gently on the edges of the back cover to snap it into
place.
7. Using a ³₁₆-inch hex key, fully retighten the two socket
head cap screws securing the handlebar bracket.