Philips 608669 - Manual (Page 7)

OPERATION
7 Viper R Upright Vacuum Cleaner (06–03)
3. Pull and turn quick-release hook to remove power
cord (Figure 6).
FIG. 6
4. Plug power cord into a grounded wall outlet
(Figure 7).
Grounded
3 Hole Outlet
Ground Pin
FIG. 7
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with the
use of an extension cord.
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Activate ON/OFF switch.
WARNING: Do Not Pick Up Flammable Or
Toxic Materials, Burning Or Smoking Debris.
2. Lower handle to operating position by stepping on
handle release latch (Figure 8).
NOTE: Brush motor will not start until handle is lowered.
FIG. 8
3. Begin vacuuming floor. Operate machine with a
back and forth motion or “W” pattern.
4. To operate in the horizontal position, lower handle
to the stop point and step on release latch again
(Figure 9).
Operating
Position
Upright
Position
Horizontal
Position
FIG. 9
5. To stop vacuuming, raise handle to the upright
position and turn off power switch.
ELECTRONIC SENSOR SYSTEM
The machine’s Electronic Sensor System monitors the
condition of the machine while operating. The sensor
light, located on the bag compartment lid (Figure 10),
will indicate the following conditions:
Green Light = Machine Functioning Properly.
Home Find... Go To..