ProForm 495Pi PFTL33105.0 - Manual (Page 6)

ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wrenches and your own phillips screwdriver ,
rubber mallet , adjustable wrench , and wire cutters .
For help identifying the assembly hardware, see the drawings below. If a part is not in the parts bag, first
check to see if it has been pre-assembled.
1. Make sure that the power cord is unplugged.
Have a second person hold the Upright Base (48) in the
position shown, with the wheel holes at the top. Identify
the Left Upright (31), which has two latch holes in one
side. Orient the Left Upright as shown, and attach it to
the Upright Base with two Upright Bolts (40) and two
Upright Star Washers (39).
Do not tighten the Upright
Bolts yet. Note: There may be left and right stickers on
the Uprights and on the Upright Base.
Handrail Star
Washer (19)–4
1
Nut (47)–4 Frame Bolt (32)–2
Console
Bolt (22)–2 3/4” Screw (2)–6
Upright/Wheel Bolt (40)–6
Upright Star
Washer (39)–4
Frame Washer
(33)–2
1/4” Star Washer
(21)–2
Handrail Bolt (20)–4
Silver Ground
Screw (27)–2
Wheel Spacer
(44)–4
48
Wheel Holes
Latch
Holes
40
39
31
1
6