Plantronics WG101/B - Manual (Page 10)

Plantronics Savi User Guide 10
out of range warning
If you are on a call, you will hear the audio degrade as you move
out of range.
If you stay out of range, active calls will be suspended. Calls will
be re-established when you walk back into range.
Low battery warning
A repeating high/low tone pair every 10 seconds indicates the
battery is low. You should recharge the headset immediately.
Checking battery level
You can check the battery level by moving the call control button
to the volume down position, then pressing inwards and holding
for two seconds. The headset indicator will flash red to indicate
the remaining battery charge level.
One red flash = low charge level
Two red flashes = medium charge level
Three red flashes = high charge level
turning headset indicator blue flash
on/off
By default, the headset indicator flashes blue to indicate the
headset state as described in the section
Headset indicator
lights and tones . This feature may be disabled by moving the call
control button to the volume up position, then pressing inwards
and holding for two seconds. The headset indicator will show a
short burst of blue flashes.
Repeat this operation to turn the headset blue flashing indicator
back on.
mute warning
When mute is activated, you will hear a single low tone which will
repeat every 30 seconds.
Pairing headset to USB adapter
The headset and USB adapter are supplied paired to each other.
However, if you wish to use a replacement headset with your
existing USB adapter, the units can be paired to each other by the
following method:
1 Ensure your replacement headset is fully charged.
2 Power the headset off by pressing and holding the call
control button for six seconds. The headset indicator light
will be red for four seconds.
3 Place the headset in pairing mode by pressing and
holding the call control button until the indicator light
flashes red and blue.
4 Place the USB adapter in pairing mode by pressing
and holding the pairing button on the adapter for two
seconds. The pairing light will flash red and blue.
5 When the pairing light on the USB adapter goes solid
blue, the headset and the USB adapter are paired.
notE: Take care when pairing the USB adapter. Do not press
hard. Please “press” with both fingers rather than push on the
USB adapter to avoid damage to the USB adapter or USB port.