Premier Mounts EST150 - Manual (Page 8)

EST150
Page 8 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Please review the Operator’s Manual that came packaged with your projector before attaching the upper
mounting bracket. The correct throw distance (the distance from the projector to the screen) must be
determined prior to mounting the projector.
1) Refer to the projectors User’s Manual to
determine the distance from the lens to
the front of the screen (X).
2) Measure the distance from the front of
the lens to the center of the projector (Y).
3) Measure the distance from the wall to the
face of the whiteboard/screen (Z).
4) Add all measurements (X + Y + Z) to
determine projector placement on the
arm assembly. This measurement
will determine where the center of the
mount bracket will be located on the
arm assembly. Please make note of this
measurement.
Front Lens
Rear Lens
Calculations
X = Manufacturers recommended
throw distance
Z = Distance from wall to face of
whiteboard/screen
Front Lens Throw Distance =
(X + Y + Z)
Rear Lens Throw Distance =
(X - Y + Z)
Throw Distance Calculation
The EST150 can be also used as
a wall-mounted standard projector mount as
well as a short throw projector mount. Align
the projector facing the opposite direction
from the wall plate to project the image
across the room. Please take into account
the projectors throw capabilities prior to
mounting in the projector opposite direction.
Proceed to the “Projector Installation” section.
Projector Installation
Locate the mounting points on the bottom of the projector
(see arrows).
Proceed to the “Attaching the Mount Carriage” section.
Attaching the Projector to the Mount Carriage