Princess PI 1010A - Manual (Page 14)

DATE PRINTED: 2/8/05 Revision Date: 02/01/05 PI-1010A Page 14
Specifications
Specification PI1010A
Minimum heat output 6,200 Btu/hr
Maximum heat output 38,500 Btu/hr
Overall efficiency, weighted average Method, 81 1/2%
Wood capacity (approximate)
White oak 60 lbs.
Fir 40 lbs.
Recommended wood length 15 - 16 inches
Total weight, with firebrick 325 lbs.
Overall Height and Width, (including shroud) 28 3/4 inches x 43 1/4 inches
Width of firebox enclosure (behind shroud) 25 inches
Width of Fan housing to Thermostat housing 34 inches
Overall Depth, 25 1/2 inches
Overall Height 23 inches
Distance from shroud front to flue collar 6 inches
Minimum size floor protector (in Canada) 31 1/4 inches x 41 inches
Minimum size floor protector (in USA) 29 1/4 inches x 41 inches
Door opening width 16 3/8 inches
Door opening height 8 3/16 inches
Flue size, diameter 6 inches
Expected Burn Time (Low Setting) 20+ hours
Combustion Chamber Cu. Ft. 2.85
Emissions (Weighted Average EPA) 2.0G
Minimum Fireplace Opening Size 25 1/2” (w) x 23 1/2” (h) x 13”(d)
Door glass Corning, Pyroceram II, Clear View Plus ™ 5 mm thick or equivalent
10 1/4 x 15 3/4 inches
Minimum chimney cross-sectional area (unless approved by your local inspector)
6” flue 28.25 sq. inches
The Facts On BTU’s:
There are only two rating methods that mean something to you the consumer. The first is the Btu output that is
achieved during EPA testing. This testing is quite complicated and costly milled woods are burned. This is a
standard for all manufacturer testing and is not intended to provide consumers with a model for how a stove will
burn in their home. The second method that counts is what Blaze King refers to as the “Real World” method.
These btu’s are achieved during in house testing using the same thing a consumer burns, split, dry, cordwood.
In our tests, we use fir. The “Real World” btu’s listed are what the average consumer can expect to achieve, with
slight variations depending upon geographical location, type of wood, elevation and the amount of fuel added.
Higher btu’s are possible. If you were to stand in front of your stove and frequently add fuel, burn the unit on high
and have optimal conditions, the PI1010 could produce as high as 87,500 btu’s
. However, maximum btu’s would
only be achievable at certain “peak” times during the burn. Blaze King does not wish to mislead you so we give
you all the facts.
Btu Ratings PI1010A
Average EPA Test Fuel (Low Burn) 10,633 Btu/hr
Average EPA Test Fuel (High Burn) 35,767 Btu/hr
Average Real World Btu’s (Low Burn) 6,200 Btu/hr
Average Real World Btu’s (High Burn) 38,500 Btu/hr
Tested and listed to U.L. 1482 and ULC 628 by OMNI-Test Laboratories Inc., (O-TL).
Certified to comply with July 1990 particulate emissions standards of the U.S. Environmental Protection Agency.