Panasonic AG 527DVDE - Manual (Page 15)

15
Initial Setup
*Important:
If a remote control button does not work when pressed, press the button on the remote
and try the button again.
Manual Clock Set
If AUTO CLOCK SET was incomplete, manually
set the clock as follows.
Press ACTION on the Remote to
display SET CLOCK Menu screen. 1
SET : SET
SELECT :
END : ACT I ON
SET CLOCK
DST : ON
SELE CT MONTH
Press to select the month and
press SET to set. In the same
manner, select and set the date,
year, time, and DST. (Daylight
Saving Time)
2
Press ACTION twice to start
CLOCK and exit. 3
Reset all unit Memory Functions
When moving unit to a new location, or if a
mistake was made in the Initial Setup section.
• Make sure a tape is not inserted in the unit.
Note to CABLE system installer:
This reminder is provided to call the CABLE (Cable TV) System
Installers attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and, in particular, specifies that
the cable ground shall be connected to the grounding system of
the building, as close to the point of cable entry as practical.
1
2
3
Turn the unit
Power on.
Press and hold both PLAY and FF
on the unit for more than 5
seconds.
• The power will shut off.
• Please ignore “NO CASSETTE” warning.
Perform “Initial Setup” on page 14.