PC Concepts 500PS - Manual (Page 132)

The Front Panel Menu Structure Navigating the Menu System Message Descriptions

Media & Ink Introduction Front Panel Other
Printer
Options
Index Solutions
Install missing cartridges
before replacing printheads You are replacing printheads, but the printer has detected that one
or more cartridges are missing. The missing cartridges must be
installed before the printheads are replaced.
Follow the procedure for
Printhead Replacement . Press the Enter or
Cancel key to continue.
Open window and check
printhead cover is properly
closed You have replaced one or more printheads and the printer’s check
has found that the printhead cover is not securely closed.
Open the window and check the printhead cover. The procedure is
described in the
Printhead Replacement procedure.
Note: This message may also appear following a paper jam, as the
printer cannot detect the exact reason for the problem. In this case
you may have to resort to powering off the printer or even removing
the power cable from the machine, in order to recover from the
problem. See
Clearing a Media Jam .
Open window and check
proper installation of setup
printheads During system start-up, which occurs when you first install the
printer, you need to install the setup printheads. These special
printheads cannot be used for printing, but must be used when the
printer has been powered off. The printer has detected that the
setup printheads have not been installed correctly.
Open the window and follow subsequent instructions to reinstall or
relocate the setup printheads. Contact HP for advice if the setup
printheads are missing or cannot be installed correctly.
Front Panel Messages (continued)
Message Explanation and Action
For more Messages, click on the Next Page button