Pioneer 2010 NAVIGATION UPGRADE SD-CARD CNSD-130FM - Manual (Page 82)

You can listen to the radio by using the naviga-
tion system. This section describes operations
for radio.
1 Press the SRC/OFF button to display the
“TUNER” screen.
= For details, refer to Switching the audio
source on page 79.
2 Press BAND/ESC button repeatedly
until the desired band is selected.
If you want to select AM, press
BAND/ESC
button repeatedly until
“AM” appears in the
display.
Reading the screen
1 2 3
5
6
7
4
1 Source icon
Shows which source has been selected.
2 Band
Shows which band the radio is tuned to: FM1,
FM2, FM3 or AM.
3 Preset number indicated next to “P.CH”
Shows what preset item has been selected.
4 Frequency
5 Signal level indicator
6 LOCAL indicator
Shows when local seek tuning is on.
= For details, refer to Tuning in strong sig-
nals on the next page.
7 STEREO indicator
Shows when the selected frequency is being
broadcast in stereo.
Using the touch panel keys
1
1 to :
Recalls radio stations.
= For details, refer to Storing and recalling
broadcast frequencies on the next
page.
Operating by hardware
buttons
Pressing the BAND/ESC button
Band can be selected from among
FM1, FM2,
FM3, or AM.
Pressing MULTI-CONTROL up or down
You can recall radio stations assigned to pre-
set tuning keys
to .
Pressing MULTI-CONTROL left or right
The frequencies move up or down step by
step.
Pressing and holding MULTI-CONTROL
left or right
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
p You can cancel seek tuning by pressing
MULTI-CONTROL left or right.
Pressing the center of MULTI-CONTROL
The function select screen appears.
En
82
Chapter
16 Using the radio (TUNER)