Peg-Perego GT3 - Manual (Page 21)

BROKEN OR MISSING.
• ALWAYS USE THE FIVE-POINT SAFETY BELTS.
ALWAYS USE THE LEG DIVIDER TOGETHER WITH THE
WAIST BELT.
• LEAVING THE CHILD ALONE IN THE PRODUCT MAY
BE DANGEROUS.
• ALWAYS SET THE BRAKE WHEN AT A STANDSTILL.
• BEFORE USING, MAKE SURE THAT ALL FASTENERS
ARE PROPERLY ATTACHED.
• BEFORE USING, MAKE SURE THE CAR SEAT OR
CARRIER SEAT IS CORRECTLY FASTENED.
• DO NOT STICK FINGERS INTO THE MOVING PARTS.
• MAKE SURE YOUR CHILD IS OUT OF THE WAY WHEN
ADJUSTING DEVICES SUCH AS THE HANDLEBAR,
BACKREST, ETC.
• ANY LOAD ON THE HANDLEBAR OR HANDLES
MAY UPSET THE PRODUCT. FOLLOW THE
MANUFACTURERʼS INSTRUCTIONS ABOUT MAXIMUM
LOAD.
• THE FRONT BAR IS NOT DESIGNED TO HOLD THE
CHILDʼS WEIGHT. THE FRONT BAR IS NOT DESIGNED
TO RESTRAIN THE CHILD IN THE SEAT; IT MUST NOT
BE USED AS A SUBSTITUTE FOR THE SAFETY BELT.
• DO NOT PLACE OBJECTS WEIGHING MORE THAN
5 KG. IN THE BASKET. DO NOT PLACE OBJECTS
IN THE DRINK-HOLDER THAT ARE HEAVIER THAN
THE WEIGHT PRINTED ON THE DRINK-HOLDER.
NEVER PUT HOT DRINKS INTO THE DRINK-HOLDER.
FOR MODELS WITH HOOD POCKETS, DO NOT PUT
OBJECTS WEIGHING MORE THAN 0.2 KG. INTO THE
POCKETS.
• DO NOT USE THE PRODUCT NEAR STAIRWAYS OR
STEPS. DO NOT USE NEAR SOURCES OF HEAT, OPEN
FLAMES, OR DANGEROUS OBJECTS WITHIN THE
CHILDʼS REACH.
• USING ACCESSORIES THAT HAVE NOT BEEN
APPROVED BY THE MANUFACTURER MAY BE
DANGEROUS.
• DO NOT USE THIS PRODUCT WHILE JOGGING OR
SKATING.
- Raise the Ganciomatic fasteners.
- Pull the footboard upwards to the top position.
- The GT3 Naked chassis is now ready for fastening
the Navetta bassinet unit.
- Pick up the bassinet unit by the handlebar and
place it on the Ganciomatic fasteners on the
chassis, placing the head of the bassinet unit
opposite the chassis handlebar.
- Using both hands, press downwards on the sides
of the bassinet unit until it clicks into place.
- To remove the Navetta bassinet unit from the
chassis, see the instruction manual that comes
with the Navetta.
GT3 Naked + PRIMO VIAGGIO
61• To fasten the car seat to the chassis:
- Set the brake on the GT3 Naked chassis.
- Attach the front bar.
- The GT3 Naked chassis is now ready for fastening
the Primo Viaggio car seat.
- Pick up the car seat by the handlebar and place
it on the Ganciomatic fasteners on the chassis,
placing the head of the car seat opposite the
chassis handlebar. Using both hands, press
downwards on the sides of the car seat until it
clicks into place.
- To remove the car seat from the chassis, see the
instruction manual that comes with the Primo
Viaggio.
ACCESSORY LINE
62• Diaper-Changing Bag: Satchel with pad for
changing babyʼs diaper. Attaches to the stroller.
63• Mosquito Netting: Mosquito netting zips onto the
hood.
CLEANING & MAINTENANCE
Your product requires only minimal maintenance.
Cleaning and maintenance operations must be
performed only by adults.
• Be sure to keep all moving parts clean, lubricating
them with light oil if necessary.
• Dry off metal parts to prevent rusting.
• Regularly clean the plastic parts with a damp cloth.
Do not use solvents or similar products.
• Brush the fabric parts to remove dust.
• Remove any dust and sand from the wheels.
• Protect the product against smog, water, rain and
snow. Continued and extended exposure to sunlight
can change the colours of many materials.
• Store the product in a dry area.
• To wash the lining, carry out the following
instructions.
WARNING
• THIS VEHICLE WAS DESIGNED FOR THE TRANSPORT
OF 1 CHILD IN THE SEAT. DO NOT EXCEED THE
INTENDED NUMBER OF PASSENGERS
• THIS VEHICLE IS DESIGNED FOR CHILDREN FROM
BIRTH TO A WEIGHT OF 15 KG.
• THIS VEHICLE HAS BEEN DESIGNED TO BE USED IN
COMBINATION WITH GANCIOMATIC PEG PEREGO
PRODUCTS: NAVETTA, PRIMO VIAGGIO, PRIMO
VIAGGIO SIP.
• ASSEMBLY AND PREPARATION FOR USE MUST BE
CARRIED OUT BY ADULTS ONLY.
• DO NOT USE THE PRODUCT IF PARTS OF IT ARE