ProForm PFTL99106.0 - Manual (Page 7)

7
4. With the help of a second person, carefully raise the
Uprights (84) to a vertical position.
Have the second person hold the console assembly near
the right Upright (84) as shown. Look under the console
assembly and locate the Console Wire Harness (78).
Cut the plastic ties securing the Upright Wire Harness
(77) to the right Upright (84). Next, connect the Upright
Wire Harness to the Console Wire Harness (78).
Make
sure to connect the connectors properly (see the
inset drawing). The connectors should slide together
easily and snap into place. If they do not, turn one con-
nector and try again.
IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED ON. 84
77
78
4
Console
Assembly
77
78
2. Attach two Base Pads (82) to the base of the Uprights
(84) with two 1" Tek Screws (22) as shown.
82 82
84
22
2
3. Identify the Right Base Cover (107). Attach the Right
Base Cover to the base of the Uprights (84) and the
Extension Leg (89) with five Screws (3).
Be careful not
to overtighten the Screws.
With the help of a second person, carefully tip the
treadmill onto its other side. Attach the left Extension
Leg (not shown) as described in steps 1 through 3.
89
84
3
107
3
3