ProForm PFEL4905.0 User Manual

Page 12

Advertising
background image

12

Monitor your progress with the display.

The upper half of

the display will

show the elapsed

time, the distance

(total revolutions)

you have pedaled,

and the resistance

level of the pedals. The display will change from

one mode to the next every few seconds. Note:

When a program is selected (except for pulse pro-

gram 2), the display will show the time remaining

in the program instead of the elapsed time.

The lower half of

the display will

show your pedal-

ing speed (revolu-

tions per minute

[RPM]) and the

approximate num-

ber of calories you have burned. The display will

change from one mode to the other every few

seconds. The lower half of the display will also

show your heart rate when you use the handgrip

pulse sensor (see step 5).

Measure your heart rate if desired.

If there are

sheets of clear

plastic on the

metal contacts

on the handgrip

pulse sensor,

remove the plas-

tic. Next, hold the

handgrip pulse

sensor with your palms resting on the contacts.

When your pulse is detected, the heart-shaped

indicator in the lower half of the display will flash

each time your heart beats, and your heart rate

will be shown.

For the most accurate heart rate reading, continue

to hold the handgrip pulse sensor for about 30

seconds. Note: If you continue to hold the hand-

grip pulse sensor, the display will show your heart

rate for about 30 seconds. The display will then

show your heart rate along with the other modes.

If your heart rate is not shown, make sure that

your hands are positioned as described. Avoid

moving your hands excessively or squeezing the

metal contacts too tightly. For optimal perfor-

mance, periodically clean the metal contacts

using a soft cloth; never use alcohol, abrasives,

or chemicals.

Turn on the fan if desired.

To turn on the fan

at low speed, press

the fan button. To

turn on the fan at

high speed, press

the fan button a

second time. To

turn off the fan,

press the fan button a third time. Note: If the fan

is turned on but the pedals are not moved for thir-

ty seconds, the fan will automatically turn off to

conserve the batteries.

Rotate the thumb tab on the right side of the fan

to adjust the angle of the fan.

When you are finished exercising, the console

will automatically turn off.

If the pedals are not moved for a few seconds, the

time will begin to flash and the console will pause.

If the pedals are not moved for a few minutes,

the console will turn off and the display will be

reset.

7

6

5

4

Contacts

Thumb

Tab

Advertising