Problems and solutions for programmed recordings, Programming a recording (without video plus+), Problemsand solutionsfor programmed recordings – Philips DVR User Manual
Page 36: Problem solution, Programming a recording (timer), The video recorder will not operate, Cassette is ejected during recording, Error message: ' no cassette, Will flash in the video recorder display, Cassette was ejected assoon asthe
32
Problemsand solutionsfor programmed
recordings
PROBLEM
SOLUTION
The video recorder
will not operate
b
While a programmed recording is being made, you cannot operate your video recorder manually.
If you want to cancel the programmed recording, press STANDBY/ON m .
'SWITCH TO
STANDBY- TIMER
RECORDING' flashes on
the TV screen
b
The video recorder was switched on several minutes before the start of a programmed recording.
Switch off the video recorder with STANDBY/ON m . A programmed recording (timer) will
only function if the video recorder is switched off.
Cassette is ejected
during recording
b
The end of the tape was reached during recording.
Error message: 'NO
CASSETTE'
k
' will flash
in the video recorder
display
b
No cassette was inserted. Insert a cassette and switch off the video recorder using
STANDBY/ON m
.
Cassette was ejected
assoon asthe
OK
button was pressed
b
A cassette was inserted with the security tab removed. Undo the erase protection (chapter
'Manual Recording', section 'Preventing accidental erasing of cassettes') or insert a different
cassette.
Error message: 'ALL
TIMERS OCCUPIED'
b
If this error message appears after pressing TIMER k , then all TIMER blocks are already
programmed. No more recordings can be programmed. If you want to clear a programmed
recording (TIMER block), select it with P ;q or P =r and then press CLEAR (CL) .
Programming a recording (without
VIDEO Plus+)
1
Switch on the TV set. If required, select the programme number for
the video recorder.
2
Press TIMER k on the remote control twice . A free TIMER block
will be highlighted.
3
Press TIMER k . The information will appear on the screen.
TIMER
VPS
DATE
REP.
PROG. START PDC END
21
MO-FR
01
20:00
]
21:30
________________________________
REP.pSELECT
STOREpOK
4
With
TIMER k
,
SqP or QSr you can select 'DATE'
(date), 'PROG.' (programme number), 'START' (start time) and 'END'
(end time).
Enter or change your information with P ;q or P =r , or with the
number buttons 0-9 on the remote control.
Programming a recording (TIMER)