Pentax IC-360 - Manual (Page 12)

III. VersaCam IC Series Installation Summary, Connection, & Placement
Summary
•
Connect an Ethernet cable between the VersaCam IC-360 Ethernet Port and your local
network.
•
Connect the Power Supply to your VersaCam IC-360. Confirm that the Network
Status LED blinks
•
Install the setup program for the VersaCam IC-360 on a PC on your local network.
•
Assign an IP address to the VersaCam IC-360 and configure the administrator’s data.
•
Configure the users’ data.
•
Disconnect the IC-360 from the local network and place it for your application* then
re-connect power and an Ethernet connection.
•
Set the preset aiming positions as desired.
* You must use a specialized bracket for ceiling attachment of VersaCam IC-360.
Caution
• Please note that exposing the camera lens to direct sunlight may cause
permanent CCD (charged coupled device) damage.
•
If your application demands prolonged or direct exposure to sunlight, you should
consider a sunshade.
VersaCam IC-360 User’s Guide 6