Panasonic DMR-XW350 - Manual (Page 19)

19
RQT9429
Quic
k Star
t
Guide
4
Press [e, r] to select “On” or “Off”
and press [OK].
OK
RETURN
Power Save
On
Off
On: Minimises standby power consumption,
disables Quick Start function. Unit’s Display
is set to “Automatic”.
Off: Enables Quick Start function.
On:
It will go into the Power Save mode when the power is
turned off.
Off:
It is possible to start quickly from standby mode.
The features of the power save function when the unit is in
standby mode are as follows.
Power Save On 1 Off 2
Power consumption Approx. 0.7 W Approx. 10 W
Start up time Not Quick Quick 3
1 “Unit’s Display” is fi xed to “Automatic” in the Setup menu.
( ➡ 88)
2 “Unit’s Display” is changed to “Bright” in the Setup menu.
3 It is possible to startup and start recording within several
seconds.
– Depending on the type of TV or the connected terminal,
it may take time to display the screen.
After Power Save setting is complete, TV aspect setting
screen appears.
5
Press [e, r] to select the TV aspect
and press [OK].
16:9
Pan & Scan
Letterbox
4:3 TV
TV Aspect
16:9 WIDE TV
OK
RETURN
16:9:
When connected to a 16:9 widescreen television
Pan & Scan:
When connected to a 4:3 aspect television,
side picture is trimmed for 16:9 picture
( ➡ 114).
Letterbox:
When connected to a 4:3 aspect television.
16:9 picture is shown in the letterbox style
( ➡ 114).
When television picture appears, set up is complete.
To stop partway
Press [RETURN ].
■ To confi rm that stations have been tuned
correctly (➡ 85)
■ To restart set up (➡ 85)
■ Download from the TV
If this unit is connected to a Panasonic TV (VIERA) supporting
HDAVI Control 3 or later via an HDMI cable, then the setting
information on the TV is acquired by this unit when the unit is
turned on for the fi rst time. Please proceed to the following steps.
RETURN
Download from TV
Download in progress. Please wait.
RETURN : to cancel
After Download from TV is complete, Power Save setting
screen appears.
Press [e, r] to select “On” or “Off” and press [OK].
OK
RETURN
Power Save
On
Off
On: Minimises standby power consumption,
disables Quick Start function. Unit’s Display
is set to “Automatic”.
Off: Enables Quick Start function.
When television picture appears, set up is complete.
To stop partway
Press [RETURN ].
Note
Acquisition of the setting information is not supported by all
Panasonic TVs (VIERA).
The acquisition may take some time depending on the VIERA
setting information.
If Region Selection screen is displayed, please go to step 3 on
page 18.
DMR-XW450_GL_en.indb 19 DMR-XW450_GL_en.indb 19 2009/04/08 午前 10:06:04 2009/04/08 午前 10:06:04