Philips FW P88 - Manual (Page 14)

14
English
3139 116 19721
OPERATING THE SYSTEM
Switching the system ON
• Press CD, TUNER, TAPE or AUX.
You can also switch on the system by
pressing any one of the CD DIRECT PLAY
buttons.
Switching the system to
standby mode
• Press STANDBY ON or B on the
remote control.
™ The system will switch to standby
mode.
Switching the system to power
save mode
(when Demonstration mode
is stopped)
• Press POWER SAVE to switch to
energy saving mode ( < 2 watts ).
™ "LOW POWER STANDBY ON" will
be displayed, after which the display
screen goes blank.
™ The low power STANDBY ON LED
will be lit.
Note:
– if the demonstration mode has not been
disabled, it will resume 5 seconds later.
DIM 1 - normal brightness with
Spectrum Analyzer Off
DIM 2 - half brightness with Spectrum
Analyzer On
DIM 3 - half brightness with Spectrum
Analyzer Off and all LEDs on the
system will be switched off.
Volume Control
Adjust VOLUME to increase or decrease
the sound level.
For Personal Listening
Connect the headphones plug to the n
socket at the front of the system. The
speakers will be muted.
Sound Control
For Optimal sound listening, you can
only select one of the following sound
control at a time : PERSONAL, DSC,
VEC or BASS/TREBLE.
PERSONAL SOUND
You can store upto 6 personal settings.
1 Press to select the PERSONAL feature.
2 Adjust the JOG to select the desired
Personal setting.
™ The selected personal setting number
will be encircled.
™ If no name has been stored
previously, " PERSONAL X" will be
displayed. " X" is the setting number.
Selecting the Source
• Press the respective source selection
button: CD, TUNER, TAPE or AUX.
™ The display indicates the selected
source.
Note:
– For an external source, make sure you
have connected the audio left and right
OUT terminals of the external
equipment (TV, VCR, Laser Disc player,
DVD player or CD Recorder) to the AUX/
CDR IN terminals.
Dim mode
You can select the desired brightness for
the display.
• Press DIM to select DIM 1, DIM 2,
DIM 3 or DIM OFF display mode.
™ The
DIM appears on the display.
™ "DIM 1", "DIM 2", "DIM 3" or
" DIM OFF" will be displayed
depending on the mode selected.
DIM OFF - normal brightness with
Spectrum Analyzer On
pg 01-31/P88/22-Eng 3/6/00, 1:26 PM 14