Panasonic DMC-FX90 - Manual (Page 29)

29
(ENG) VQT3S29
Troubleshooting
First, try out the following procedures.
• Check “ Troubleshooting ” in the “Owner’s Manual for advanced features (PDF
format)”.
• The battery is exhausted. Charge the battery.
• If you leave the camera on, the battery will be exhausted.
> Turn the camera off frequently by using the [Economy] etc.
• Insert the battery securely all the way in.
• Is the mode set to [Rec] Mode?
• Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available
memory.
• You may not be able to record for a short while after turning the power [ON]
when using a large capacity card.
[Failed to connect wireless access point]/[Connection failed]/
[No destination found]
• Check following regarding the wireless access point (broadband router).
> The wireless access point (broadband router) information set on this unit is
wrong. Check the authentication type, encryption type, and encryption key.
> Power of the wireless access point (broadband router) is not turned on.
> Setting of the wireless access point (broadband router) is not supported by
this unit.
• Check the network setting of the destination.
If the problem is not resolved, it may be improved by selecting [Reset] on the
[Setup] menu when taking pictures.
Battery and power source
The camera cannot be operated even when it is turned on.
The camera turns off immediately after it is turned on.
Card/battery door does not close.
Recording
The picture cannot be recorded.
DMC-FX90P-VQT3S29_eng.book 29 ページ ２０１１年８月２２日 月曜日 午後３時５８分