Panasonic 47/55 CLASS 1080P LCD HDTV TC-47LE54 - Manual (Page 9)

9
Attaching the pedestal to TV
■
Assembling the pedestal
Fix securely with assembly screws A
(Total 4 screws).
Tighten screws firmly.
Accessories
Assembly screws
(4 of each)
A
XSS5+15FNK size
(M5 x 15)
B
XYN4+F25FJK size
(M4 × 25)
Bracket (1)
TBL5ZA32821
Base (1)
TBL5ZX0270 (for 47”)
TBL5ZX03841 (for 55”)
A
Bracket
Front
Base
Make sure that the bracket is
anchored before fixing the screws.
(Image)
■
Set-up
Tighten assembly screws B (total 4 screws) loosely at first,
then tighten them firmly to fix securely.
Work on a flat surface
B Rear side
Arrow
mark
Hole for pedestal
installation
bracket
Base
Rear view
Arrow
mark
(Image)
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall
hanging bracket or repacking the TV.
Remove the assembly screws B from the TV.
Lift the TV from the pedestal.
Remove the assembly screws
A from the bracket.
WARNING
Do not disassemble or modify the pedestal.
Otherwise the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any pedestal other than that provided with this TV.
Otherwise the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic
Dealer immediately.
During set-up, make sure that all screws are securely tightened.
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure. (above)
Otherwise the TV and/or pedestal may fall over and become damaged, and personal injury may result.
tc_47_55le54.indb 9 tc_47_55le54.indb 9 3/2/2012 1:45:20 PM 3/2/2012 1:45:20 PM