Peerless Industries OneMount RTONE - Manual (Page 5)

5 of 33 ISSUED: 09-20-06 SHEET #: 202-9167-3 01-26-07
Attaching Tilt Brackets to Screen using Baffled Fastener Pack
NOTE: Refer to page 4 for adjustments of top extension bracket.
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place
screen face side down. Refer to screen manufacturers instructions or customer service, for removing any knobs, base,
cover, or screw(s) on the back of the screen to prepare mounting. These need to be removed to allow the adapter brack-
ets to be attached. Select the small, medium, large or extra large screws from the baffled fastener pack then attach tilt
brackets to screen following figure 2.3 or 2.4.
NOTE: Be sure to attach tilt brackets with knobs facing outward as in figure 2.1.
NOTE: Top and bottom mounting holes must be used for attaching brackets. Middle holes should also be used where the
fasteners and screens allow. Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
NOTES:
• Always use multi-washers when attaching tilt brackets
(BB and CC) to your screen when using small, medium or
large screws. No multi-washer is required for extra large
(M8) screws.
• Use the corresponding hole in the multi-washer that
matches your screw size as shown in fig 2.2.
• Tighten screws so adapter brackets are firmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
MULTI-WASHER
fig 2.2
MEDIUM HOLE FOR M5 SCREWS
LARGE HOLE FOR M6 SCREWS
SMALL HOLE FOR M4 SCREWS
fig 2.1
BB
CENTER BRACKETS
VERTICALLY ON
BACK OF SCREEN
X
CC
X
KNOBS FACE OUT
Note: "X" dimensions should be equal.
NOTE: For flat back screens proceed to step 2-3. For bump-out or recessed back screen skip to step 2-4