Philips SLV4200 EN - Manual (Page 10)

10 Getting started
b. Plug the adapter into the power
outlet.
c. The green LED on the front panel
should be on.
Note: if it is not the case, press the ON/
OFF switch on the back of the product.
5. Check that TV1 is working well
a. Switch on TV1
b. Check that TV1 is working well.
c. Switch on the connected video
source for the video source
chosen.
d. Check if TV1 shows the image of
the video source.
> The transmitter is connected
correctly.
3.2 Install the remote control
blaster cord
The remote control blaster cord
transmits IR signal to Source devices.
1. Switch off the transmitter (A).
2. Connect the remote control blaster
cord (F) to the IR socket.
3. Position the blaster light in front of
the video source. Just put it in front
of the IR sensor on the front panel.
Note: See the FAQ “How can I find the IR
sensor on the video source?” for locating
the IR sensor on the front panel of the
video source.
3.3 Connect receiver
Preparation
- Switch on the transmitter (A).