ProForm PFEL91030 User Manual
Page 9
9
12. Plug one end of the Power Supply (115) into the jack
at the rear of the elliptical crosstrainer. Plug the other
end of the Power Supply into an appropriate outlet
that is properly installed in accordance with all local
codes and ordinances.
Note: The Console (5) can be operated with batteries
(not included) instead of the Power Supply (96) if
desired. To install batteries, follow the instructions
below.
See the inset drawing. Press the indicated tab on the
battery drawer and pull the battery drawer down.
Press four “D” batteries into the battery clips;
make
sure that the batteries are oriented as shown by
the markings inside of the battery clips. Then,
close the battery drawer. Note: Alkaline batteries are
recommended.
12
13.
Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may
be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical crosstrainer.
11. Attach the Left Handlebar Cover (109) to the Console
(5) with three M4 x 16mm Screws (66). Attach the
Right Handlebar Cover (110) in the same way.
See assembly step 9. Tighten the eight M6 x 16mm
Tapered Button Screws (107).
11
5
66
66
109
110
96
Power
Jack
Batteries
Battery
Drawer
5
Tab