Panasonic KX-MC6040 - Manual (Page 71)

9. Programmable Features
71
Approving users for the LAN
connection
{#}{
5}{3}{2}
{ 0} “ Disabled” (default): Deactivates this feature.
{ 1} “ Enabled”: The unit will deny/approve access from the pre-programmed
IP patterns. Whether to deny or approve, and up to 4 patterns can be
programmed through the web browser interface.
1. Start Multi-Function Station.
2. [Utilities] i [Configuration Web Page] i [Network Configuration]
3. Type “root” as the user name, then enter the password (feature #155 on
page 57). i [OK]
4. Select the [LAN Feature] tab.
5. Click [Edit] next to [Approved Users].
6. Click [Edit] next to [Filter].
7. Change the mode and edit IP filtering information. i [Submit]
8. Close the web browser.
Setting the IP address
automatically for the LAN
connection
{#}{
5}{3}{3}
This feature will be displayed only when feature #500 is activated.
{
0} “ Disabled” (default): Deactivates this feature.
{ 1} “ Enabled”: IP address will be allocated automatically without using a
DHCP (Dynamic Host Configuration Protocol) server.
Setting HTTPD for the LAN
connection
{#}{
5}{3}{4}
{ 0} “ Disabled”: Denies access to the web browser.
{ 1} “ Enabled” (default): Allows access to the web browser.
IPv6 protocol
{#}{
5}{3}{5}
{ 0} “ Disabled” (default): Deactivates this feature.
{ 1} “ Enabled”: IPv6 protocol can be used. After installing the printer driver, be
sure to change the port to IPv6 protocol. You can check the IPv6 protocol
address by printing the “
Setup List” (page 104).
Note:
L To activate this feature, you need to turn the power switch of the unit OFF,
then ON.
Setting the paper input tray to
use for the scan to e-mail
print feature
{#}{
5}{6}{5}
This feature will be displayed only when the optional input tray is installed.
{
1} “ #1” (default): Standard input tray
{ 2} “ #2”: Optional input tray
{ 3} “ #1+#2”
Note:
L If you select “ #1+#2”, make sure the same paper size is selected for the
following:
–
Standard input tray (feature #380 on page 58)
– Optional input tray (feature #382 on page 58)
If either is changed, “ #1” will be selected automatically.
Feature/Code Selection