Panasonic WV-CL920 - Manual (Page 29)

-30-
8. Adjust the horizontal phase by pressing or
. The adjustable range is 0 - 2.0µs.
9. Move the cursor to SC COARSE.
10. Press or to match the chroma phase of the
camera’s video signal, when observed at the out-
put of the Special Effect Generator (SEG) or
Switcher, as closely as possible to the color of the
original scene. (SC COARSE adjustment can be
incremented in steps of 90 degrees (4 steps) by
pressing or .)
Note: After the fourth step, the adjustment returns
to the first step.
11. Move the cursor to SC FINE.
12. Press
or to match the color (hue) of the
camera’s video signal, when observed at the out-
put of the Special Effect Generator (SEG) or
Switcher, as closely as possible to the color of the
original scene.
The SC FINE adjustment has a range of 90
degrees of color shift.
Notes:
• When the “I” cursor reaches the “+” end, it
jumps back to “
−
” . At the same time, SC
COARSE is incremented by one step to enable
a continuous adjustment. The reverse takes
place when the “I” cursor reaches the “
−
” end.
• When or is kept pressed for a second
or more, the “I” cursor moves faster.
• For more accurate adjustment, supply both the
original camera video output signal and the
effect output video signal (program output
video signal) of the special effects generator
(SEG) to a vectorscope and compare the chro-
ma phase of both signals.
• To reset SC COARSE and SC FINE to the val-
ues preset at the factory, press and
simultaneously.
1 (1 - - 4): 0 degrees
2 (1 - - 4): 90 degrees
3 (1 - - 4): 180 degrees
4 (1 - - 4): 270 degrees