Philips DCR 9001/22 User Manual
Page 41
88
EN
You have made several setting changes and you want to restore the default volume control assignment settings
(see table in next paragraph)
Default volume control assignment means:
in TV mode, volume control is performed through a Philips brand TV set
in VCR mode, volume control is performed through a Philips brand TV set
in DVD mode, volume control is performed through a Philips brand TV set
in AMP mode, volume control is performed through a Philips brand amplifier only.
To restore default settings:
- Simultaneously press keys 1 and 3 until the indicator surrounding the
key blinks twice then release these keys.
- Enter code 981.The indicator surrounding the
key blinks twice.
15.3 Changing the brand setting of your remote control for your TV,
VCR, DVD or Amplifier
By default at first power up or at first installation, your universal remote control is pre-set to control your Digital Receiver as well
as most Philips brand audio/video devices.
If you have other brands of devices, or if the presets do not enable you to control your Philips device, please follow the procedure
below.
1
Choose one brand code, made up of 4 digits, from the code list at the end of this manual. (If several codes are possible, go
through this procedure with the first code and try your remote control. If you are not successful, repeat the procedure with
the second code, and so on).
2
Press the SELECT key repeatedly to choose the mode corresponding to the type of device you want to set up (TV,VCR, DVD
or Amp/Tuner).
3
Simultaneously press digits 1 and 3 until the indicator surrounding the
key blinks twice then release these keys.
4
Enter the 4 digit code corresponding to the device brand you have chosen.The indicator surrounding the
key blinks once
after each one of the first three entries.The indicator surrounding the
key blinks twice after the fourth entry.
If an invalid code has been entered, the indicator surrounding the
key blinks once only. Restart from step 1.
We advise you to fill in the table below to keep a record of your personal remote control settings.This will be helpful the day you
have to replace the remote control batteries (see Note 1 below).
1 Battery change
If the battery change takes more than 1 minute the remote control may return to the Philips default settings.Therefore you have
to proceed with a new setting of your remote control with the help of the table above for your non-Philips branded devices.
2 Disclaimer
All manufacturers are concerned about the constant improvement of their products. Although your remote control is
compatible with most of the equipment of the following list, Philips cannot guarantee its operation with the complete range of
products on the market.
Default setting
Your personal setting
Brand
Code
Volume control
performed through
Brand
Code
Volume control
performed through
M
O
D
E
TV set
Philips
0556
TV
Video rec.
Philips
0081
TV
DVD
Philips
0539
TV
Amp.
Philips
1742
AMP
STB
STB 1
TV
STB (1 or 2)