Philips DS7530 - Manual (Page 5)

5 EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Connect power
This docking speaker can be powered by either
AC power or batteries.
Option 1: AC power
Caution
• Risk of product damage! Make sure that the power
supply voltage matches the voltage printed on the type
plate. The type plate is located inside the stand foot of
the docking speaker.
• Risk of electric shock! When you unplug the AC
adapter, always pull the plug from the socket. Never
pull the cord.
Connect the AC power adapter to:
• the power socket at the back of the
docking speaker.
• the wall socket.
Option 2: Battery power
Caution
• Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
• Remove batteries if they are exhausted or will not be
used for a long time.
• Batteries contain chemical substances, so they should
be disposed of properly.
1
Open the battery compartment.
2
Insert 4 x 1.5V AA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Turn on
Switch the power button to ON position to
turn on the docking speaker.
» The LED indicator lights up.
Switch to standby mode
The docking speaker switches to economic
standby mode in the following situation:
• The speaker is idle for 15 minutes when
powered by AC supply;
• The iPod/iPhone or external audio device
is disconnected when the speaker is
operated on batteries.
» The LED indicator lights off.
PUSH