Panasonic AJ-D650 - Manual (Page 33)

Setup (setting) menus
USER menu
<TIME CODE>
Item Setting
No.
Superimposed No. Superimposed
Description
display display
5 0 0 VITC 0000 10L This sets the position where the VITC signal is to be inserted.
POS-1 0001
11L (The same line as for VITC POS-2 in 501 cannot be
0002 12L
selected.)
0003 13L
0004 14L
0005 15L
0006 16L
0007 17L
0008 18L
0009 19L
0010 20L
501 VITC 0000 10L This sets the position where the VITC signal is to be inserted.
POS-2 0001
11L (The same line as for VITC POS-1 in 500 cannot be
0002 12L
selected.)
0003 13L
0004 14L
0005 15L
0006 16L
0007 17L
0008 18L
0009 19L
0010 20L
502 VITC 0000 BLANK This selects whether to output the VITC data to the positions
BLANK 0001 THRU selected by VITC POS-1 in 500 and VITC POS-2 in 501.
0: Data is not output.
1: Data is output.
503 TCG 0000 TC&UB This selects the signal to be regenerated when the time code
REGEN 0001 TC generator (TCG) in the REGEN mode.
0002 UB
0: Both the time code and user bit are regenerated.
1: Only the time code is regenerated.
2: Only the user bit is regenerated.
504 REGEN 0000 OFF This selects whether values used in the internal time code
MODE 0001 ON generator are preset from the front panel or remote controller
or synchronized with time code values read from the tape.
0: Values are preset from the front panel or remote
controller. (PRESET)
1: Values are synchronized with time code values read from
the tape. (REGEN)
505 EXT TC
SEL
506 BINARY
GP
0000
0001
0000
0001
0002
0003
0004
0005
0006
0007
<Note>
When “1” is selected, values selected at set up menu No.503
(TCG REGEN) are regenerated.
LTC This selects the time code to be used when an external time
VITC code is to be used.
0: The LTC of the TIME CODE IN connector is used.
1: The video signal VITC is used.
000 This sets the usage status of the user bit of the time code
001 generated by the TCG.
010 0: NOT SPECIFIED (character set not specified)
011
1: ISO CHARACTER (8 bits character set based on lSO646,
100
lSO2022)
101
2: UNASSIGNED 1 (undefined)
110
3: UNASSIGNED 2 (undefined)
111
4: UNASSIGNED 3 (undefined)
5 : PAGE/LINE
6: UNASSIGNED 4 (undefined)
7: UNASSIGNED 5 (undefined)
The underline on the setting item denotes the initial setting.
– 3 3 –