Pioneer PRV-LX10 - Manual (Page 74)

74
PRV-LX10
En
Edit List File Format
Edit list files are text files with the “.edl” filename extension. Composition is as follows:
Header: PIONEER-DVDRec-EDL 002 ENCODING=XXX
Entry: Number Operation Type Parameter 1 Parameter 2 Parameter 3
The number of parameters differs depending on the type of operation involved. Numbers are consecutive
numerals beginning from 001.
Use a single-byte space (0x20) or tab (0x09) between [PIONEER-DVDRec-EDL] and [002]. Alternately, a carriage
return character (0x0A, 0x0D0A, 0x0D) may also be used.
The message ENCODING=XXX indicates the character encoding, and may be omitted.
The “XXX” represented here supports utf8, eucJP, Shift-JIS, and JIS7. If the command is omitted, utf8 will be
used as default encoding.
■ IN/OUT Point Setting Entry
Number Operation Type Parameter 1 Parameter 2 Parameter 3
NNN REC IN Point OUT Point Post-REC action
The IN/OUT point is set using time code format as follows: HH:MM:SS:FF
Post-REC action will indicate either STOP or PAUSE.
The final IN/OUT point setting entry in an edit list must always designate the post-REC action as STOP.
■ Chapter Point Setting Entry
Number Operation Type Parameter 1
NNN CHP CHAPTER POINT
The chapter point is designated using time code as HH:MM:SS:FF. The chapter point description must come
immediately below the IN/OUT point setting to which it is applied. Also, the Number value is given as that
given to the IN/OUT point setting entry.
■ DVD-RW disc initialization
Number Operation Type
NNN INI
Initialization can be applied only at the head of an edit list entry.
■ Finalize
Number Operation Type
NNN FNL
Finalizing can be applied only as the final entry of an edit list.
■ Wait
Number Operation Type Parameter
NNN WAI Comment
The wait command can be used within a list, to designate points necessary to change a VTR tape, etc.
If a comment is input, the comment will appear in the wait dialog.
If the comment is separated by a tab (0x09), it will appear split into two lines at the point of the tab.
■ Designating the Encoding Parameter
Number Operation Type Parameter 1 Parameter 2
NNN SET Rate Filter
Rate is R:n (n= 1-32)
Filter is F:n (n= 0-16)
This setting will continue to be reflected after EDL execution.
Importing Image Data, Edit Lists