ProForm PFEVEL29010 User Manual
Page 6
6
8. Identify the Left Pedal (13). Attach the Left Pedal to the
Left Pedal Arm (14) with three M4 x 19mm Flange
Screws (17) as shown. Note: The Left Pedal can be
attached in any of three positions (see HOW TO
ADJUST THE PEDALS on page 8).
Attach the Right Pedal (not shown) in the same way.
Make sure that both Pedals are in the same position.
17
14
13
6. Whilst another person holds the Console (5) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (82). Insert the
excess wire harness into the Upright (2).
Attach the Console (5) to the Upright (2) with three
M10 x 27mm Screws (71) and three M10 Split
Washers (70). Be careful to avoid pinching the Wire
Harnesses.
Snap the bookrack onto the Console (5) where shown.
6
5
82
71
71
7. Apply a small amount of the included grease to the left
and right axles on the Upright (2).
Identify the Left Handlebar (9) (refer to the drawing on
page 3, if necessary). Carefully slide an Upright Spacer
(26), a Handlebar Spacer (25), the Left Handlebar, and a
Handlebar Cap (23) onto the left axle on the Upright (2)
as shown. Slide an M10 Small Washer (53) onto an M8 x
19mm Button Screw (22), and tighten the Button Screw
into the axle.
Attach the Right Handlebar (10) in the same way.
Grease
7
8
2
Wire Harness
70
70
71
26
25
9
2
10
23
22
53
10
5. The Console (5) requires four “D” batteries (not includ-
ed); alkaline batteries are recommended. Press the tab
on the battery cover, and lift off the battery cover.
Insert four batteries into the Console. Make sure that
the batteries are oriented as shown by the mark-
ings inside the battery compartment. Reattach the
battery cover.
5
Tab
Batteries
Battery
Cover
5
Bookrack