Planar PDP 42 - Manual (Page 23)

2 3
How to use as PC Monitor
1. Turn on the PDP and press on the remote controller.
2. Use to select RGB1(Analog) and then press .
(If the PC output is set to Digital, select RGB2(Digital).)
3. This PDP does not support Plug & Play function. When setting the PDP, select default.
4. Set the PC video output mode to VGA (640 480)/ SVGA (800 600)/ XGA (1024 768). In the
mode higher than SXGA (1280 1024), "Out of Range" message appears. Be sure to change
your PC video format to less than XGA mode. (Please refer to page 51 for the modes that PDP
supports)