Panasonic SL-SX332 - Manual (Page 3)

OPEN
A
Remote control
Main unit
≥ The configuration of the AC adaptor differs according to the area.
≥ The battery indicator ( ) scrolls while recharging and disappears when finished
(about 4 to 5 hours).
≥ You can recharge the batteries before they are fully discharged.
≥ Fit the battery lid so it is secure and flush with the battery compartment. If it comes
loose, it may scratch your discs.
Location of controls/Connection to other equipment
Power Supply
References to the remote control apply only to SL-SX332.
As a safety precaution this unit is constructed so it is impossible to recharge
ordinary batteries. For details, check with your dealer.
Rechargeable batteries (not included)
Charge before initial use.
1 2 3
Dry cell batteries
After disconnecting the AC adaptor, insert two “LR6, AA, UM–3” alkaline
batteries.
Insert the same way as the rechargeable batteries.
The battery indicator
DC IN jack
S-XBS 7
2 2 0: The unit switches off shortly after
the indicator starts flashing.
This indicator appears when the unit is on.
AC adaptor
To household
mains socket
When charging, use only the following
Panasonic rechargeable Ni-Cd batteries.
The United Kingdom: P-3GAVE/2B (set of 2)
Other areas: P-3GAVT/2B (set of 2) You can not charge any other
type of rechargeable/dry cell
batteries.
∫ Play time
➪Specifications, page 2
∫ Removing batteries
General
VOLTAGE ADJUSTOR
110-127V 220-240V
If the power plug will not fit your
socket, use the power plug
adaptor.
Except for the United Kingdom, Australia,
N.Z., China and sets purchased in Japan
The unit is in the standby condition when the AC adaptor is
connected. The primary circuit is always “live” as long as the AC
adaptor is connected to an electrical outlet.
≥ Before playing starts the battery indicator may flash although the
batteries are not drained. It appears correctly once you start play.
Turn the unit off before recharging.
∫ For SL-SX325
Be sure to obtain the optional AC adaptor
The United Kingdom: RFEA435B-S Australia and N.Z.: RFEA436A-S
3
SL-SX325 SL-SX330
Close
securely.
Adjust the volume
level on the audio
system.
Memory/Recall/
Anti-skip mode
selection(MEMO)
Battery
compartment Hold switch
Headphone jack
Open switch
Skip/Search (:, 9)
Play/
Pause (1/;)
Stop/Turn off (∫)
Volume control (j, VOL, i)
To DC IN jack
Display panel
Play mode selection (MODE)
Audio system
To CD or AUX
terminals
Sound quality
selection (EQ)
Some cannot
be connected.
Car audio
Lens
Plug type:
3.5 mm stereo
Volume control
Play/Stop/
Turn off
Skip/Search
Sound quality selection/Operation tone on-off
Earphones
Hold switch
SL-SX332
SL-SX332
To Household
mains socket
Audio cable (not included)
≥ Set the unit’s volume to 10-15.
≥ Turn the operation tones off so they are not
heard when operating the remote control.
Car stereo cassette adaptor (SH-CDM10A)
(not included)
≥ Set the unit’s volume to 10 -15 .
Through to headphone jack (Ë) SL-SX332
Directly to headphone jack (Ë)
SL-SX325 SL-SX330
≥ Connect remote control to main unit first.
AC adaptor
(Purchase AC adaptor for )
The United Kingdom: RFEA435B-S
Australia and N.Z.: RFEA436A-S
≥ The configuration of the AC adaptor
differs according to the area.
SL-SX325
Car power adaptor (SH-CDC9) (not included)
≥ You can recharge the batteries with this
connection.
≥ When you switch off the car, the volume
returns to 10.
Turn off this unit and the other equipment before connection.
Plug type:
3.5 mm stereo
Be sure to set the proper voltage in your
area before use.
Screw driver
Connect the AC adaptor to the household
mains socket first.
Except for the United Kingdom,
Australia, N.Z. and China