ProForm PFBE3006.0 - Manual (Page 5)

5
ASSEMBLY
1.
Make sure that the Left Seat Base (3) is oriented
as shown. Attach a Seat Base Bumper (31) to the
Left Seat Base with an M4 x 16mm Self-tapping
Screw (91) and an M4 Washer (84).
Attach a Bench Foot (15) to the Left Seat Base
(3) with two M4 x 16mm Self-tapping Screws (91)
and two M4 Washers (84).
Repeat this step with the Right Seat Base (2).
Make sure that the Right Seat Base is oriented
as shown.
1
Before beginning assembly, make sure you
understand the information in the box
above.
2
3
31
84
91
15
91
84
Before beginning assembly, carefully read the
following information and instructions:
• To hire an authorized service technician to
assemble the weight bench, call toll-free
1-800-445-2480.
• Assembly requires two persons.
• Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
In addition to the included hex key and grease
packet, the following tools (not included) are
required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by anyone. Most people find that by
setting aside plenty of time, assembly will go
smoothly.