Philips 60PP 9601 - Manual (Page 45)

POSITION
2 1 3
5 4 6
8 7 9
0
TV VCR ACC
GUIDE
AV
INFO
SWAP PIP CH
DN UP
SOURCE FREEZE
FORMAT
VOL CH
MUTE
SURF 100+
POWER
AUTO
STATUS/
EXIT
MENU/
SELECT
POSITION
2 1 3
5 4 6
8 7 9
0
TV
GUIDE
AV
INFO
SWAP PIP CH SOURCE FREEZE
FORMAT AUTO
STATUS/ EXIT
VOL CH
MUTE
SURF
POWER
TV VCR ACC
1 2 3
6 5 4
7 8
0
9
100+ SURF
DN UP
MENU/ SELECT
3
2
4
1
PIP
PIP
S
ETTING THE
TV R
EMOTE TO
W
ORK
A
CCESSORY
D
EVICES
N ow that you have looked up
the three-digit Remote
Code Number for your brand of
accessory device (see page 45-
46), you are ready to follow the
simple steps shown below.
Please read through all the
steps before beginning.
Press and release the correct
VCR or ACC(essory) System
button.
Press and release the center
Menu button.
Within thirty seconds after
releasing the center Menu
button, ENTER THE THREE
DIGIT CODE NUMBER for
the desired device. The remote
is now ready to send commands
to the accessory.
Point the remote at the
accessory device. Press the
POWER button on the remote to
turn the device ON.
1
2
3
4
STOP
VCR
S
MART
H
ELP
Remember, if this does
not work the first time,
repeat steps using the same remote
code number.
If after a second try the remote
does not operate your accessory
device, and there are more code
numbers listed for your brand, use
the next listed code number.
If after repeated attempts the code
number method does not work
your accessory device, try the
"SEARCH METHOD" shown on
the following page.
BEGIN
45
DIRECT ACCESS METHOD
DVD
CABLE TV CONVERTER
SATELLITE RECEIVER
Note: For TV remote’s equipped
with a backlight option, the unit may
“blink” or flash as the three-digit
Direct Access code numbers are
entered on the keypad. (Two blinks
indicate a valid code number entry
has been accepted; one long blink
indicates an invalid code number or
the thirty second time interval for
entering code numbers has expired.)