Pioneer VSX-D811S - Manual (Page 49)

Controlling the rest of your system 09
49
En
Selecting preset codes
directly
CHANNEL
ENTER
ENTER
MPX/RETURN DTV INFO
DTV ON/OFF DTV MENU
D.ACCESS T.EDIT/GUIDE
ST
TUNE
T P SE U
TUNE
ST
CLASS
FL DIMMER
BAND
TOP MENU AUDIO SUB TITLE
REMOTE SETUP
RECEIVER CONTROL
STANDARD ADV.SURR. STEREO
ANGLE
1 ¡ 4 ¢
7 8 3 ¶
LEVEL
DVD VCR CD-R TV
RCV TUN TVC CD
TEST TONE
CH SELECT
INPUT ATT
INPUT SEL. MUTE MIDNIGHT/ LOUDNESS SIGNAL SEL
MULTI CONTROL
EFFECT DISPLAY
DISC
+10
RECEIVER SOURCE
1 2 3
4 5 6
7 8 9
0
1 Press and hold REMOTE SETUP for three
seconds.
The LED lights steadily for two seconds.
2 Press the MULTI CONTROL button for
the component you want to control.
3 Use the number buttons to enter the 4
digit preset code (see pages 56–67)
The LED blinks for half a second after you input
each digit and shows a long, two second blink
once you have entered a valid code. If the LED
blinks three times it means an invalid code has
been input or an error has occurred.
• If you assign a preset code for the TUNER
button, you won’t be able to control the
built-in tuner of this receiver using the
remote. Reset the remote to the built-in
tuner by entering the preset code
7008.
4 Repeat steps 1 through 3 for the other
components you want to control.
Setting the remote to control
other components
There are several ways to set your remote to
control the other components in your system.
The easiest way to do this is to assign the
component’s manufacturer preset code (listed
on pages 56–67) to one of the
MULTI CONTROL
buttons on the remote control.
The buttons can be set to control the following
components:
Controllable Components
DVD or LD player
TV or Satellite tuner
VCR or Digital Video Recorder
CD player
CD Recorder, Tape deck
or MD player
TV or Cable TV tuner
FM/AM tuner
Button
DVD:
TV:
VCR:
CD:
CD-R:
TVC:
TUN:
You can do this directly, or by searching
through different preset codes until you find the
right one. If you can’t find a preset code that
matches the component you want to control,
you can still teach the remote individual
commands from another remote control (page
50).
You can cancel or exit any of the steps by
pressing and holding
MUTE for three seconds.
XRB3013A.49.67 01.12.12, 4:48 PM 49