Pentair Hot Tub Skimmer - Manual (Page 2)

P/N 99130000 2 Rev. B 5-9-02
Item Part Number Description
1 98216000 Screw 8-18 3/4" Phil. Flat S.S.
2 85017300 Plug, large
3 85017400 Plug, Small
4 85017000 Plate, skimmer, small
4A 85017100 Plate, skimmer, long
5 86204000 AGF. body
6 46135200 Gasket, thin AGF.
7 85107200 Plate, securing
8 86204100 90° close, el-nut
9 87200100 Nut, AGF.
SAVE THESE INSTRUCTIONS!
II. Installation Procedures.
A. Cut 2 - 3/8" diameter hole approximately 5-1/2 inches below water level.
B. Assemble thin gasket back of fitting body followed by securing plate and second thin gasket.
C. Assemble threaded end of fitting body through hole in spa wall.
D. Assemble thick gasket on back side of spa wall over fitting body and thread on elbow not or lock nut
(dependent on model being installed).
E. Place skimmer plate with small mounting hole at bottom so it aligns with boss at bottom of securing
plate. Secure plate with screw, do not over tighten.
F. Align skimmer plate in vertical position. Using top hole in skimmer plate as guide, drill 9/64"
diameter hole through spa wall.
G. After placing silicone on threads of second screw and in skimmer plate hole, use screw to secure top
of skimmer plate. Tighten both top and bottom screws.
H. Install large plug in top hole and smallplug in bottom hole.
III. Replacement Parts