Panasonic DMP-B200 - Manual (Page 11)

G
e
tti
n
g
st
arted
VQT3C15
11
∫ Detaching the battery pack
When not using for long periods of time
≥ Detach the battery pack (> above).
(Even when the unit is turned off, there is a small amount of
voltage running through the unit, and this may result in a
malfunction.)
≥ Recharge the battery for re-use.
∫ Recharging the battery pack
Attach the battery pack and connect the AC adaptor (> 10).
The [CHARGE] indicator (> 8) lights while charging the battery, and
the [CHARGE] indicator turns off when battery charging is finished.
≥ “ECO-charge”(> 29) function can be used with this unit.
Charging mark is displayed for a few seconds on the lower
right of the screen while the power is “Off”.
∫ Approximate recharging and play times (Hours)
≥ Play time indicated above may differ depending on the use.
∫ Checking the remaining battery charge
Not displayed when the AC adaptor is in use.
Press [SUB MENU] while the power is “On”
Remaining charge is displayed for a few seconds at the bottom
right of the screen.
Charge the battery pack when the display starts to flash.
≥ Appears automatically when there is only a few minutes of
charge remaining.
≥ The power may turn off without the display flashing when the
media is played back with the battery low on charge.
Before connection, consult your car owner’s manual or your dealer.
≥ Connect to the cigarette lighter socket of a vehicle that has a 12 V
battery. It is not compatible with a vehicle that has a 24 V battery.
≥ This is a special negative grounded Car DC Adaptor. Using
this Car DC Adaptor with a plus grounded car can cause
malfunction and lead to fire.
1
Connect the car DC adaptor to the unit.
2
Connect the car DC adaptor to the cigarette
lighter socket.
Replacing the fuse
Replace only with the specified 125 V/250 V, 3.15 A fuse.
Use of any other type can cause fire.
1 Open the socket.
2 Replace the fuse.
3 Close the socket.
Cautions
≥ To avoid draining your car battery
jDisconnect the Car DC Adaptor from the cigarette lighter after
use. The Car DC Adaptor continues to consume some power
even if it is not being used, and if a battery pack is attached to
this unit, it will start recharging which uses more power.
jDo not use the Car DC Adaptor for long periods when the
engine is not running.
≥ Leave some slack in the cord.
≥ No responsibility will be taken for damage that occurs due to
faulty installation.
“ECO-charge”
is set to “On” “ECO-charge”
is set to “Off”
Battery pack
Recharging *1
*1 at 20 oC (68 oF) / using headphones / LCD brightness level is “s5”
(> 13, “Adjusting the pictures on the LCD screen”).
Play *1,*2
*2 When the battery pack is recharged setting “ECO-charge” to “Off”
(When the battery pack is recharged setting “ECO-charge” to “On”,
the battery duration is about 80 %.)
“ECO-charge”
“Off” “On”
DY-DB20
(supplied)
4 3.25 4
DY-DB30
(optional)
5 4 5
DY-DB300
(optional)
7 5.5 8
RELEASE
DETACH ATTACH
Bottom side of this unit
2 Slide.
1 Press and hold.
ᵣ ᵡ ᵭ
Recharge
(flashing) Fully charged
Connecting the supplied Car DC
Adaptor
1 2
Car DC Adaptor (supplied)



125 V/250 V, 3.15 A type
VQT3C15~Body1_mst.fm 11 ページ ２０１０年１２月２７日 月曜日 午後２時４分